Large Selection of Quality Concrete, Mansonary & Specialty Fasteners

2. Specialty Tapcons

A. Tapcon Coated or 410 SS

B. Scotts Tapson 304 Stainless Head

C. Tapcon XL

D. Tapcons Maxi Set

D. Trim Head Tapcons for window installation

3. Nail-In Anchors, drive pin anchors

4. Zac Anchors

5. Sleeve Anchors

6. Drywall Screws

7. Hex Slotted sheet metal screws for HVAC or other thin guage metal

8. Phillips Pan Head Framer-for heavy 16-20 guage metal stud

9. Square drive trim head—Finish screw for application of base board or trim through D?w to heavy 12-20 ga stud.

10. Phillips Modified Truss Head—For application of metal lathe to heavy 12-20 ga metal studs.

11. Eagle Rock—wafer head, high-low thread spade point recommended for the application of cement board to plywood

12. Phillips Pan Head Self Drill—for fastening electrical boxes to studs, stud framing, and heavy metal stud framing

13. Ply-Metal Self drill with or without wings– Plywood to light gauge metal framing—reamer wings eliminate plywood pre-drilling

14. Phillips Flat Head Self Drill w/wings—for wooden headers or planks to metal frames

15. Hex washer head self drillers without washers used for HVAC ductwork assemblies, metal to metal fastening and heavy guage

16. 410 Stainless steel Hex washer head self drillers with or without washers